Proceedings, Volumen181Institution of Mechanical Engineers, 1967 |
Dentro del libro
Resultados 1-3 de 20
Página 83
... front rolls ( in ) . Diameter and width of rear rolls ( in ) Weight / in width - front rolls ( lb / in ) Weight / in width - rear rolls ( lb / in ) Grid roller 12 ton 26 880 82 36 24 ton 6 160 51 34 x 34 36 x 16 80 142 20 ton 45 ton 44 ...
... front rolls ( in ) . Diameter and width of rear rolls ( in ) Weight / in width - front rolls ( lb / in ) Weight / in width - rear rolls ( lb / in ) Grid roller 12 ton 26 880 82 36 24 ton 6 160 51 34 x 34 36 x 16 80 142 20 ton 45 ton 44 ...
Página 92
... front roll was introduced together with improvements in transmission design , prominent among these being the ... front to rear roll diameter with approximately two - thirds of the machine weight on the rear rolls . Rear roll width is ...
... front roll was introduced together with improvements in transmission design , prominent among these being the ... front to rear roll diameter with approximately two - thirds of the machine weight on the rear rolls . Rear roll width is ...
Página 93
... front roll steering lock of about 45 ° each side is usually achieved and this results in a turning circle radius over the outside of the front roll of 35 per cent 65 per cent front roll rear roll Without ballast 142 229 Water ballast ...
... front roll steering lock of about 45 ° each side is usually achieved and this results in a turning circle radius over the outside of the front roll of 35 per cent 65 per cent front roll rear roll Without ballast 142 229 Water ballast ...
Contenido
Fair Copying Declaration | 16 |
The effects of physical factors on ignition delay | 34 |
Design parameters of a machine suitable for testing automotive friction materials | 61 |
Derechos de autor | |
Otras 8 secciones no mostradas
Otras ediciones - Ver todas
Proceedings Institution of Mechanical Engineers (Great Britain). Automobile Division Vista de fragmentos - 1959 |
Proceedings Institution of Mechanical Engineers (Great Britain). Automobile Division Vista de fragmentos - 1956 |
Términos y frases comunes
air velocity ambient temperature application automatic automatic transmission Automobile Division B.Sc brake brake bands C.Eng cent Cetane chamber clutch combustion compactor components compression ratio compression temperature constant cost cranking speed curve cycle cylinder D.I. engines diameter diesel engine disc drive dry density effect efficiency engine speed Engrs factors force frequency friction material fuel consumption furrow gas turbine gearbox given heat hydraulic hydrostatic transmissions ignition delay injection input investigation layer lb/in² abs lubricating machine mass loss maximum measured mile/h minimum moisture content motor normal number of passes obtained operation output paper performance petrol PINTAUX piston pneumatic-tyred roller production pump range reduced rev/min road roller roll shown in Fig slip angle stoichiometric surface temperature and pressure tion top dead centre torque torque converter transmission tyre valve variables vehicle vertical load viscosity weight wheel